The era of traditional routers and range extenders has passed. In contemporary times, Linksys Velop Intelligent Mesh System has become the talk of the town. These improve the range of your WiFi network and offer you a seamless internet connection. However, over time, users face a few issues.
Let us get you through each issue so that you learn how to resolve them. Keep reading.
Checking for Internet Connection
You might be having a strong internet connection. However, your Linksys Velop AC2200 is not detecting an active internet connection. What will you do in that situation? Let’s know about that.
You can head to the “I want to enter my ISP settings manually” link. When you click that, you get access to the static IP address option. Apart from that, you even get access to the following options.
- Contact my ISP
In this option, you get basic instructions to get in touch with your Internet Service Provider.
- Static IP Address
The first step will be to connect to the default Linksys Velop SSID. After that, you have to put in the static IP.
- PPPoE Account
Under this option, you are going to connect to the default Linksys Velop Intelligent Mesh WiFi to enter PPPoE information.
- VLAN ID with PPPoE
In this step, you need to use the VLAN ID to enter the PPPoE information.
- Continue Without Internet
To complete the Linksys Velop setup without installation, you can also choose the Skip option to continue without internet. However, if you do that, you will have to manually configure the internet settings later on.
Can’t Log in Using Router’s Admin Password
When you set different Linksys Velop nodes, you get a default administrative password. This will help in securing your node. It comes in handy in case your Linksys Velop Intelligent Mesh System is not activated. However, what if you can’t use the default admin password? Well, it could be a major issue and does not permit you to access the nodes. Let’s resolve it.
- Start with doing the Linksys Velop router. You can even use Linksys router login IP to proceed further.
- The second step includes opening the Velop Administration.
- Further, the ‘Change Velop Password and Hint’ option pops on your home screen. Click on it.
- Choose the Admin Password option and change it.
- Add a new password for the Linksys Velop AC2200.
- Don’t forget to set the Password Hint. It will help you in case you forget the password.
- Save changes.
If the above troubleshooting tips do not work out, you might have to recover the admin password first. When nothing works out, go for the reset option.
Resetting Linksys Velop Nodes
As mentioned above, resetting your Linksys Velop Intelligent Mesh WiFi network to default settings could be an option. However, make sure you do it if nothing else works. Because after you reset the device, all the devices will be disconnected.
Reset Secondary Node
Locate the reset button on your secondary nodes, and press and hold it until the LED light blinks red. It is going to restore the secondary node to the primary settings.
Reset Primary Node
To reset the primary node, follow the step mentioned above. Apart from that, you need to further reset the secondary node as well to completely reset the Linksys Velop Intelligent Mesh WiFi Network.
Wrap Up
The above given are some of the most common Linksys Velop Intelligent Mesh WiFi issues. Therefore, you must follow the troubleshooting guide for the same. Also, if the default web address fails to open, you should use the Linksys router login IP address. We hope you found this article helpful. Make sure you leave feedback in the comment section.
